Anokiwave provides off-the-shelf design solutions to solve issues in RF front end designs. Please contact us to find out if we have a solution for your current microwave/RF problem. Our IP licensing policies are very attractive. Listed below are some examples useful for increased performance of mm-Wave RF modules.

Current off-the-shelf solutions:

• Novel Bend with Reduced Insertion Loss*
• All inclusive wire-bond ready design of a "DC-to-40GHz Broadband High Power ( > 4 W) Resistor":
• Customized microstrip to wave-guide transitions.
• Custom RF board isolation improvement structures.

Novel Bend with Reduced Insertion Loss*

• Applicability for > 20 GHz Improve Signal Strength and Yield
• Works for more than +/- 16mm of Tolerance
• Up to 50% reduction in insertion loss and radiation loss compared to that from conventional Miter
• No extra cost in Manufacturing

All inclusive wire-bond ready design of a "DC-to-40GHz Broadband High Power ( > 4 W) Resistor":

Traditionally, a wire-bonded matched chip resistor requires matching on both the chip resistor and on the transmission-line substrate. Anokiwave has a method of including all of the matching on the chip resistor.

Key features: Achieve a DC-to-40GHz termination with a realistic wirebond No modification on the MMIC or Module!!. High power termination Single sided matching Save expensive chip area. Contact us to find more.

Customized microstrip to wave-guide transitions.

Please contact info@anokiwave.com for more details.

Custom RF board isolation improvement structures.

If you are having problems with RF signal integrity at board level, please contact info@anokiwave.com

* patent pending